Gt35 Gt3582 T3 Ar. 70/82 Anti-surge Compressor Turbine Psi Bearing Turbo Charger
70/82 ANTI-SURGE COMPRESSOR TURBINE PSI BEARING TURBO CHARGER. 1 X GT35 Journal Bearing Anti-Surge Turbocharger. 1 X Pre-Assembled -4AN Boost Pressure Fitting. Hardware as Shown in the Picture Above.
High Compression/ Boosting Journal Bearing GT35 Anti-Surge Turbocharger + Boost Pressure Fitting : The GT35 turbocharger assembly is designed to be used on engines displacing 2.0L-4.5L and is typically good for around 600HP. They are also commonly used in twin turbo applications.In this case those figures would be doubled 4.0L-8.0L engines up to 1200HP. Horsepower ratings are generally meant to express the turbochargers maximum airflow capability. Recommended boost pressures are 7psi. 5 Bar to 21psi(1.5 Bar) and boost pressures should not exceed 30psi(2 Bar). Exceeding 21psi(1.5 Bar) of boost pressure can significantly reduce a turbochargers lifespan. Generally speaking 14psi(1 Bar) is good for a 100% increase in horsepower from a naturally aspirated engine. Also factory non-turbo engines without forged internal components on high octane pump gas (91-92 octane) it is not recommended exceeding 7psi. Doing so could result in damaging your engine. Universal Application on Any T3 Turbo Manifold and 4 Bolts Downpipe (Besides Flanges, Please Compare the Trims Provided Above with the Targeted Engine Bay to Decide Fitment) Modification might be Required for Some Vehicles. High Compression/ Boosting Journal Bearing GT35 Anti-Surge Turbocharger + Boost Pressure Fitting. Capable of Boosting Horse Power up to 350 - 500+ BHP; Perfect for High Horse Power Application. High Quality Material, Cast Housing with Durable Steel. Journal Bearing Mechanism; Oil and Water Cooling.
- Brand: Charismatic Racing Concepts
- Manufacturer Part Number: CRC-TBCGT35SQ
- Interchange Part Number: CRC-TBCGT35SQ
- Other Part Number: CRC-TBCGT35SQ
- Placement on Vehicle: Front
- Fitment Type: Performance/Custom
- Superseded Part Number: CRC-TBCGT35SQ
- Materials: Cast Iron/Steel Turbo Housing/ Aluminum Controller
- Surface Finish: Cast
- Intake Inlet/ Outlet: 4.00"/ 2.50"
- Inlet / Outlet Diameter: 4" / 2.5"
- Compressor A/R: 0.7
- Compressor Inducer /Exducer (MM): 66.36 / 81.87
- Compressor Trim: 55
- Exhaust (Downpipe) Flange: 4-Bolt Circular
- Exhaust (Turbo Manifold) Flange: Standard T3 4-Bolt
- Turbine A/R: 0.82
- Turbine Inducer / Exducer (mm): 73.60 / 64.50
- Turbine Trim: 73