JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo

JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo

JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo

JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo

JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo

JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo

JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo   JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo

T3/T4 hybrid turbocharger assembly is created by installing a T4 compressor wheel and housing onto a T3 turbine housing wheel and center section. A T3/T4 hybrid turbocharger assembly is a compromise for engines where a T3 turbocharger is too small to reach the desired maximum horsepower but using a T4 turbocharger would create an unacceptable amount of turbo lag. The T3/T4 turbocharger is designed to be used on engines displacing 1.5L-3.0L and is typically good for around 400HP. They are also commonly used in twin turbo applications. In this case those figures would be doubled 3.2L-5.0L engines up to 800HP. Horsepower ratings are generally meant to express the turbochargers maximum airflow capability. Recommended boost pressures are 7psi(0.5 Bar) to 21psi(1.5 Bar) and boost pressures should not exceed 30psi(2 Bar).

Exceeding 21psi(1.5 Bar) of boost pressure can significantly reduce a turbochargers lifespan. Generally speaking 14psi(1 Bar) is good for a 100% increase in horsepower from a naturally aspirated engine.

Also factory non-turbo engines without forged internal components on high octane pump gas (91-92 octane) it is not recommended exceeding 7psi. Doing so could result in damaging your engine. 100% Brand new never been used or installed. Boost engine horse power significantly. Increase engine power and torque outpout. Maintain combustion chamber pressure and fuel/air load.
Contructed with high quality material. Built for durability and strength.
Accessories: Gasket included as picture shown. Standard 5 bolt T3 Downpipe Flange. 5 Bolt Standard Hot Side. Oil Inlet - 1/8 NPT Oil Inlet. Bearing Type - Journal Bearing.
8 Blade Type T4 Compressor Wheel. 2.205" Minor and 2.570" Major Propellar.
These turbos are Universal fitment they are not a direct bolt on or replacement for any vehicle additional parts will always be required for installation Professional installation is Highly recommended. Installation instruction is not included. Professional installer is highly recommended! THIS PRODUCT RECOMMENDS PROFESSIONAL INSTALLATION.
E-checks are automatically held until the established clearing date, to reduce any delays please provide a valid telephone number upon the checkout. If you're located outside of the continental USA. If this process is not completed, delays and other issues will occur. Please inspect your order upon receipt. Because we always test fit our products, it is rare that our item will have fitment issue. If in case the item you receive does not fit your car, we need to ask you for digital picture so that we can assist you. Most aftermarket items do not come with instructions and professional installation for all item is highly recommended. No exchanges will be issued on products that have been damaged or used improperly (Modified). We will work with you and solve the problem. We ALWAYS recommend professional installation. All emails are to be answered within 24 hours except Sat and Sun. What happens if the item is out of stock?

We try our best to have all items we list and since all items are constantly listed. Occasionally, due to high demand or human error we may be temporarily out of stock.

All emails will be replied in the order it was received. We usually reply within 24 hours, In some cases emails are lost in the spam or junk folder so please check them regularly. Powered by Solid Commerce The All-in-One Listing, Inventory & Order Management Solution. The item "JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo" is in sale since Friday, January 31, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Turbos, Nitrous, Superchargers\Turbo Chargers & Parts".wan10" and is located in Walnut, California. This item can be shipped worldwide.
  • Brand: Journal Bearing Oil Cooled
  • Manufacturer Part Number: 3.0" Inlet/ 2.0" Outlet AR .49
  • Interchange Part Number: T3 Flange/5 Bolt Hot Side Flange
  • Other Part Number: support up to 400HP
  • Surface Finish: Cast Steel Aluminum Bronze
  • Placement on vehicle: Front
  • Manufacturer: Journal Bearing Oil Cooled

JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo   JDM Stage 3 T3/T4.57 A/R Hybrid Turbocharger 5 Bolt Turbine Anti-Surge Turbo