T3/t4 T04e A/r. 63 Turbine Anti-surge 5 Bolt Flange Turbo Charged Turbocharger
Premier auto parts distributors of quality and performance products. 63 TURBINE ANTI-SURGE 5 BOLT FLANGE TURBO CHARGED TURBOCHARGER. This T3/T4 hybrid turbocharger assembly is created by installing a T4 compressor wheel and housing onto a T3 turbine housing, wheel and center section. A T3/T4 hybrid turbocharger assembly is a compromise for engines where a T3 turbocharger is too small to reach the desired maximum horsepower but using a T4 turbocharger would create an unacceptable amount of turbo lag.
The T3/T4 turbocharger is designed to be used on engines displacing 1.6L-2.5L and is typically good for around 400HP. They are also commonly used in twin turbo applications. In this case those figures would be doubled 3.2L-5.0L engines up to 800HP.Horsepower ratings are generally meant to express the turbochargers maximum airflow capability. Recommended boost pressures are 7psi. 5 Bar to 21psi(1.5 Bar) and boost pressures should not exceed 30psi(2 Bar). Exceeding 21psi(1.5 Bar) of boost pressure can significantly reduce a turbochargers lifespan. Generally speaking 14psi(1 Bar) is good for a 100% increase in horsepower from a naturally aspirated engine. Also factory non-turbo engines without forged internal components on high octane pump gas (91-92 octane) it is not recommended exceeding 7psi. Doing so could result in damaging your engine. Boost engine horse power significantly. Increase engine power and torque outpout. Maintain combustion chamber pressure and fuel/air load. Contructed with high quality material.
Built for durability and strength. Professional Installation is Highly Recommended.
- Brand: Zpeedstarz
- Manufacturer Part Number: ZPD-TBCT04E63SQ
- Interchange Part Number: ZPD-TBCT04E63SQ
- Other Part Number: ZPD-TBCT04E63SQ
- Placement on Vehicle: Front
- Fitment Type: Performance/Custom
- Superseded Part Number: ZPD-TBCT04E63SQ
- Materials: Cast Iron/Steel Turbo Housing/ Aluminum Controller
- Surface Finish: Cast
- Intake Inlet/ Outlet: 4.00" / 2.50"
- Compressor A/R: 0.48
- Compressor Inducer /Exducer (MM): 50.50 / 76.00
- Compressor Trim: 55
- Exhaust (Downpipe) Flange: Standard T3 5-Bolt
- Exhaust (Turbo Manifold) Flange: Standard T3/ T4 4-Bolt
- Inlet / Outlet Diameter: 4.00" / 2.50"
- Turbine A/R: 0.63
- Turbine Inducer / Exducer (mm): 65.50 / 55.90
- Turbine Trim: 73
- Horse Power Increment: 300